-Cut the insert on one side to the hole in the middle to ease removing the rooted cuts without damaging the roots.
-Fill with distilled water to recomended level and add 4 ml per gallon of B'cuzz Root Stimulator.
-Take the cuttings using the normal proceedure, dip in a rooting gel (Clonex) and insert the cutting so the bottom protrudes approx. 1". Use a piece of cotton or makeup sponge to hold cut in place.
-Be sure there's a net pot in every hole to prevent light getting to the solution. Use a netcup with cover on any empty sites.
-Add a fully submersible aquarium heater set to 78f through one of the net pots to speed the rooting process up.
-Plug the unit in and run 24/7 until rooted, usually 6-10 days depending on strain. Top off the reservoir with distilled water as needed to maintain correct level.
DO NOT allow the roots to grow into the motor/mister or you WILL burn the motor up.
These Documents contain information gathered from many Online Communities and all possible references have been given to the authors of each individual article. For any discrepancies in this please contact "overgrow2@gmail.com" ....ps enjoy